Kmc-controls STE-8000 series Instrukcja Użytkownika Pobierz pdf

Installation guide for SimplyVAV sensors

















STE-8001 STE-8201

This installation sheet applies to SimplyVAV digital

wall sensors connected to SimplyVAV

controllers. For additional information on

the SimplyVAV products, browse to the

SimplyVAV web site for videos and other

resources.

Choosing a sensor location

Install the sensor on an inside wall where it can sense

the average room temperature. Avoid locations with

direct sunlight, heat sources, windows, air vents,

and air circulation obstructions such as curtains or

furniture.

For models with motion sensing, see the topic on the

following page, Planning for motion sensing.

Rough-in preparation

Complete rough-in wiring at each sensor location

prior to sensor installation. This includes the following

items.

 If required, install an appropriate backplate.

 Route an Ethernet connecting cable from the

sensor to the controller location.

 Maximum cable length is 75 feet (22.9 meters).

Plenum-rated preassembled cables are

recommended.

Turn clockwise to

remove from base.

Turn counterclockwise

until the screws engage

the case.

Mount the sensors

To install the sensor on a mounting base, do the

following:

1. Turn the Allen screws in the base of the sensor

clockwise until they clear the case. Swing the

sensor away from the mounting base to remove it.

2. Route the Ethernet cable through the mounting

base.

3. Fasten the mounting base directly to a 2 x 4 inch

outlet box or a backplate with the Allen screws

toward the oor.

4. Insert the Ethernet cable coming from the base

into the sensor.

5. Place the top of the sensor over the top of the

mounting base and swing it down over the Allen

screw brackets. Be careful not to pinch any wiring.

6. Turn the Allen screws counterclockwise until they

back out of the mounting base and engage the

case of the sensor.

Mounting

base

Ethernet

connecting cable

Maximum 75 feet

or 22.9 meters

Allen

screws

Operation

The sensor will become operational as soon as it

is connected to an operational controller. See the

following pages to change room setpoints or congure

a SimplyVAV controller with the sensor.

Maintenance

Remove dust as necessary from holes in top and

bottom. Clean the display with soft, damp cloth and

mild soap.

1 2 3 4

Podsumowanie treści

Strona 1 - Maintenance

Installation guide for SimplyVAV sensorsSTE-8001 STE-8201This installation sheet applies to SimplyVAV digital wa

Strona 2 - Planning for motion sensing

Planning for motion sensing Typical motion sensing coverageMotion sensor vertical and horizo

Strona 3 - Changing room setpoints

Room setpoints are changed using the buttons and display on the front of the sensor. 1. Press any button to begin changing setpoints.2. If required, e

Strona 4 - ◆ Press the setpoint

/61$Override timer34"9Standby timer$!4Discharge Air TempMAXFMax. Fan Speed (%)<Calibration!5-$Auto. Occ. Mode237Set Password 1237Set Passw

Komentarze do niniejszej Instrukcji

Brak uwag

Kmc-controls STE-8000 series Instrukcja Użytkownika

Przeglądaj online lub pobierz Instrukcja Użytkownika dla Czujniki Kmc-controls STE-8000 series. KMC Controls STE-8000 series User Manual Instrukcja obsługi

Podsumowanie treści

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Czujniki Kmc-controls STE-8000 series