Kmc-controls CSE-1103 Instrukcja Użytkownika Pobierz pdf (Strona 2)

KMCControls,Inc.

19476 Industrial Drive

New Paris, IN 46553

574.831.5250

www.kmccontrols.com; [email protected]

Wiring

Accessories for the CSE-1102/1103 are the following

air ow sensing probes:

• HFO-0015, 4 inches (102 mm) long

• HFO-0016, 6 inches (152 mm) long

To install either probe:

1. Drill holes in the ducting for the 1/4" (6 mm) OD

sensor probe and the mounting screws.

2. Insert the sensor probe through the mounting

plate and into the duct.

3. Turn the sensor probe so that air ows into the

sensor’s opening.

4. Aach the mounting plate to the ducting using

screws.

5. Connect to the probe using 3/8" (9 mm) OD

exible tubing or a compression ing to 1/4" OD

copper tubing.

Optional HFO-001x Sensor Probe

Setpoint Adjustment

NOTE: To properly calibrate an air switch, a

digital manometer or other measuring

device should be used to conrm the actual

setpoint.

The adjustment range is 0.05 ±0.02 to 12.0" wc. To

adjust the setpoint:

1. Turn the adjusting screw counterclockwise until

motion has stopped.

2. Turn the adjusting screw clockwise 4 complete

turns (to engage the spring). From this point, the

next (up to) ten turns are used for the actual cali-

bration. Each full turn represents approximately

1.2" wc. For example, 2-1/2 turns (aer the initial

4 clockwiseturns) equals about 3" wc (2.5 turns x

1.2" wc per turn).

Before pressure is applied to the diaphragm, the

SPDT switch contacts will be in the normally closed

(NC) position. The snap switch has screw top ter-

minals with cup washers. Wire control and alarm

applications appropriately.

Maintenance

No routine maintenance is required. Each compo-

nent is designed for dependable, long-term reliabil-

ity, and performance. Careful installation will also

ensure long-term reliability and performance.

Dimension HFO-0015 HFO-0016

A 4" (102 mm) 6" (102 mm)

B 0.5" (13 mm) 0.5" (13 mm)

1 2

Komentarze do niniejszej Instrukcji

Brak uwag

Kmc-controls CSE-1103 Instrukcja Użytkownika Strona 2

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Przekaźnik Kmc-controls CSE-1103